SuperDevTools

Online hearing test

Before you start
  • Put on headphones or earphones, properly seated and the right way round (left on left).
  • Sit in a quiet room, away from the TV and noisy appliances.
  • Keep the volume moderate, never loud. Take the headphones off if a sound bothers you.
  • This test is only a guide: it does not replace a hearing examination.

1. Calibration

Play the reference tone (1,000 Hz, in both ears). Set your device volume so you hear it faintly but clearly, then leave the volume alone until the test is over.

2. Ear-by-ear test

Each ear goes through 7 frequencies, from 250 to 8,000 Hz. The beeps start very quiet and rise in 5 dB steps. Press “I hear it” as soon as you notice a beep, however faint. Some trials are silent: only press when you really hear something. Allow 3 to 6 minutes.

Ready. Calibrate first, then start the test.

Space bar: “I hear it”. Esc: stop everything.

Highest frequency you can hear

A pure tone rises from 8,000 to 20,000 Hz over 48 seconds, in both ears, at a moderate level. Click “I can't hear it” as soon as the sound disappears.

Typical values by age (ballpark figures)

Highest frequency heardTypical age
17,000 Hz and aboveunder 25
16,000 Hzaround 30
15,000 Hzaround 40
12,000 Hzaround 50
10,000 Hzaround 60
below 10,000 Hzover 60

Many earphones and phones reproduce sounds above 16,000 to 18,000 Hz poorly: the result also depends on your equipment.

A headphone hearing test, one ear at a time

This online hearing test plays each ear beeps that get gradually louder, at 7 frequencies: 250, 500, 1,000, 2,000, 4,000, 6,000 and 8,000 Hz. You signal the first beep you notice, and the tool draws an audiogram that compares your two ears and flags any drop in the high frequencies. A second test finds the highest pitch you can still hear.

Use it to take stock before an appointment, or to follow the effect of age and noise from one year to the next. Nothing is uploaded.

How the test works

  1. Read the “Before you start” box: headphones on, a quiet room, a moderate volume.
  2. Calibration: click “Play the reference tone”. A 1,000 Hz beep repeats in both ears. Set your device volume so you hear it faintly but clearly, then leave the volume alone.
  3. Click “Start the test”. The right ear goes first, in the order 1,000, 2,000, 4,000, 6,000, 8,000, 500 and 250 Hz, followed by the left ear.
  4. Each beep lasts 1 second, with a gentle fade in and out, so there is no click. The first sits 30 dB below the reference, and each one after that is 5 dB louder. Press “I hear it” (or the space bar) as soon as you notice a sound, during the beep or within the second after it.
  5. For every frequency, one silent trial is slipped in at random among the first few. If you press at that moment, the tool counts it as a guess.

Allow 3 to 6 minutes. “Stop the test” or Esc ends everything.

Reading the relative audiogram

Frequencies run from bass on the left to treble on the right. The vertical axis shows your threshold in dB relative to the reference tone: 0 is the level you set during calibration, -10 a sound with a tenth of the power, +20 a sound with a hundred times the power. The lower a point sits, the more the sound had to be turned up. Circles: right ear; crosses: left.

These are not dB HL, the unit used in a sound booth: your headphones are not calibrated, so only the differences count. Example: right ear, 1,000 Hz heard at -5 and 8,000 Hz at +15; left ear, 1,000 Hz at 0 and 8,000 Hz not heard. The left ear falls away in the treble, and the “Gap L − R” column shows more than 25 dB at 8,000 Hz.

Two flags can appear. High-frequency drop: for one ear, the average threshold at 4,000, 6,000 and 8,000 Hz is at least 20 dB above the average at 500, 1,000 and 2,000 Hz. Asymmetry: a gap of at least 15 dB between your ears at two frequencies or more. A tone never heard counts as +45 in these sums.

Age-related hearing loss and noise exposure

As we get older, the inner ear loses the high frequencies first. This is presbycusis. It usually affects both ears in a similar way and often starts around 8,000 Hz before reaching 4,000 Hz. People notice it when “s”, “f” and “th” blur together in a busy pub.

Noise leaves a different mark: a dip around 4,000 to 6,000 Hz, with some recovery at 8,000 Hz. Gigs, loud headphones and building sites are the usual culprits.

The highest-frequency test fills in the picture: a pure tone rises from 8,000 to 20,000 Hz over 48 seconds, and you click “I can't hear it” when it fades out. The guide figures are ballpark values: 17,000 Hz and above under 25, about 15,000 Hz around 40, 12,000 Hz around 50, 10,000 Hz around 60. Stop at 16,300 Hz and the table highlights the “16,000 Hz” row, typical around 30.

Limits of this test

  • Loose earphones let room noise in and lose bass; many reproduce sounds above 16,000 Hz poorly.
  • The device is not calibrated: compare results only with the same headphones and the same volume.
  • The beeps never exceed a safe ceiling, 40 dB above the reference.
  • Tinnitus, tiredness or a cold skew the answers.

Only an audiogram taken in a sound booth by a hearing care professional or an ENT doctor is reliable. See someone promptly if your hearing drops suddenly, or if you have pain or ringing that will not go away. Ticking “Keep the last result on this device” stores the result in this browser only; “Delete the saved result” removes it.

Frequently asked questions

How accurate is an online hearing test?

It gives you a pointer, not a diagnosis. For a figure in dB HL, you need a booth test.

Why shouldn't I turn the volume up during the test?

Calibration sets your zero point: change the volume halfway and the thresholds no longer compare. If several beeps are heard at the very lowest level, the tool asks you to turn down and start again.

What does “Responses during a silent trial” mean?

The test holds up to 14 trials with no sound at all, one per frequency and per ear. Pressing then shows you were anticipating: from two upwards, the tool suggests retaking the test.

I can't hear anything above 14,000 Hz. Should I worry?

Not necessarily: that limit drops with age, and plenty of earphones handle those frequencies poorly. For understanding speech, the 500 to 4,000 Hz range matters far more.