A sound level meter in your browser
This decibel meter listens through the microphone of your computer or phone and shows how loud it is: the “Current level (125 ms)”, the “Average (Leq)” since you started, the “Max”, the “Min” and a graph of the last 60 seconds. It all happens in the browser: no audio is recorded or sent.
A laptop or phone mic is not a measuring instrument: without calibration the reading is only a guide that can be 10 dB or more away from the true level. It is good for comparisons: a room before and after soundproofing, a quiet street at night versus rush hour.
How to use it
- Click “Start measuring” and allow the microphone. Nothing is requested before that click.
- Put the device down with the mic uncovered and leave it alone.
- “Pause” freezes the average and the graph; “Reset” clears everything.
- “Download measurements (CSV)” gives one row per second, in dB(A) and dB(Z), with the time.
What the numbers mean
From dBFS to the displayed value
The tool takes the root mean square (RMS) of the signal and expresses it in dBFS, where 0 dBFS is the loudest signal the mic can digitise. A sine wave of amplitude 1 gives −3.01 dBFS; one of amplitude 0.1 gives −23.01 dBFS. The displayed value is dBFS plus the “Calibration offset (dB)”, which starts at 100 dB. That default is a convention, not a measurement, and it means the display tops out at around 100 dB, where the mic clips.
To calibrate, place a real sound level meter next to the mic, measure for at least a second, type its reading into “Reading from a real sound meter (dB)” and click “Calibrate to this value”. Say the reference shows 55.0 dB while the tool measured −47.2 dBFS: the offset becomes 102.2 dB.
The browser's echo cancellation, noise suppression and automatic gain are switched off, because they change the level the mic picks up.
A-weighted or unweighted
A-weighting turns down low frequencies the way your ear does: −19.1 dB at 100 Hz, 0 dB at 1 kHz. Here it is a filter computed in the browser, within 1 dB of the standard curve up to about 8 kHz. “None (unweighted)” shows the raw signal as dB(Z).
Decibels are logarithmic
Adding 3 dB means twice the sound energy, so two machines at 70 dB each make 73 dB, not 140. Adding 10 dB sounds roughly twice as loud. The average works the same way: one hour at 85 dB followed by one hour at 65 dB gives an Leq of 82.0 dB, not 75 dB, because loud periods dominate.
Reference levels and your hearing
The reference list (a whisper around 30 dB, conversation around 60 dB, heavy traffic around 80 dB) is a rough guide only. In the UK, employers must act when daily noise exposure averaged over 8 hours reaches 80 dB(A), with stricter duties from 85 dB(A). Long, repeated exposure above about 85 dB(A) can damage hearing.
FAQ
Can I use it as evidence against noisy neighbours?
No. A phone mic is not a certified instrument. The CSV file helps you keep a log of times and levels, but formal complaints rely on approved equipment, usually brought in by the local council.
Why do my phone and laptop show different values?
Every microphone has its own sensitivity. With the same 100 dB offset, two devices can disagree by more than 10 dB, so calibrate each one.
Is any sound recorded?
No. Only level figures are calculated, in memory, and vanish when you close the page. The CSV holds times and numbers only.
What is the difference between Leq, Max and Min?
Leq is the steady level that would carry the same energy over the whole time measured. Max and Min are the highest and lowest 125 ms levels during the measurement, pauses excluded.